CCD BLACK AND WHITE CAMERA
The camera shall be a solid state black and white video camera. The
pick-up device shall be a 1/3" interline transfer charge coupled
device (CCD) with equal to or greater than 250,000 picture elements.
Video output shall be provided through a BNC-type connector. Composite
video output shall be 1.0V p-p with 75 Ohm impedance and shall be EIA
RS-170 standard black & white video signal format. The camera shall
accept CS-type lenses and be capable of supporting auto-iris type lenses
(video-type & DC type). Back-focus adjustment shall be provided via
a back-focus which will not require tools for adjustment. A Phillip-type
set srew will lock the back-focus ring in place after adjustment.
The camera shall have an internal isolation transformer.
The dimensions of the camera shall be 2.46"(W) X 1.97"(H) X
4.45"(D). Camera mounting shall be performed via a 1/4" X 20
threaded hole in the camera casing. The camera shall be capable of being
mounted either from the top or bottom. Camera weight shall not exceed
21.2oz. Ambient operating temperature shall +14 degrees to +122 degrees
Fahrenheit. Ambient operating humidity shall be 30% to 90%.
Camera resolution shall be a minimum of 400 TV lines horizontal and
350 TV lines vertical. Synchronization shall be achieved via line-lock
24 volts AC 60Hz. There shall be provisions for vertical phase
adjustment. Signal-to-noise ratio shall be 50dB. AGC shall be automatic
and provide a minimum 18dB gain. The sensitivity of the camera shall
render a minimum subject illumination of 0.032 Lux (F1.2). The camera
shall have auto electronic shutter capable of 1/100,000 second. The
camera shall also have provision for 4-zone user programmable back light
compensation. The camera shall have provision to boost dynamic range by
approx. 30%, selectable by user.
Camera shall be powered by a 24 VAC, 50/60Hz power source. Power
consumption shall not exceed 5.5 W. The camera shall be UL and CUL